One sealed 14-pin connector on the back of the panel: power, CAN, analog and digital inputs, sensor supply and a switched 12 V output.
Rear view of the panel, 3D model. Select the connector to open its pinout.
Select a pin on the connector or a row in the table. Colours show the signal group; select a group to highlight its pins.
Select a pin on the connector or a row in the table.
| Pin | Signal | Description |
|---|---|---|
| 1 | NC | Not connected (reserved) |
| 2 | NC | Not connected (reserved) |
| 3 | NC | Not connected (reserved) |
| 4 | NC | Not connected (reserved) |
| 5 | AIN | Analog input 0–5 V |
| 6 | CAN-H | CAN bus, high line |
| 7 | +12V | Battery supply, 7–30 V |
| 8 | GND | Power ground |
| 9 | DIN1 | Digital input, 12 V |
| 10 | CAN-L | CAN bus, low line |
| 11 | OUT | Switched 12 V output (smart switch, up to 17 A) to enable a load |
| 12 | +12V | Battery supply, 7–30 V |
| 13 | +5V | Sensor supply, 5 V (output) |
| 14 | DIN2 | Digital input, 12 V |
Pin numbering is shown from the rear of the panel.